Follow

WRN - Routing Table issue caused by the Setup Wizard

Please review the other WRN articles for the proper setup process or troubleshooting : https://support.hanwhasecurity.com/hc/en-us/sections/4402400213147-WRN-PoE-Servers

-------------------------------------------------------------------------------------------------------------------

The existing Setup Wizard is modifying the WRN routing table wrongly when using Corporate Network (2) for Internet connection. To rectify this issue , see attached document ( WRN Routing table update)

 

Please note , This solution is NOT needed if you are using Camera Network (1) ONLY for both Camera network and Internet access

 

Root Cause

mceclip0.png

mceclip1.png

mceclip2.png

 

 

mceclip3.png

mceclip4.png

mceclip5.png

 

mceclip6.png

mceclip7.png

mceclip8.png

 

mceclip9.png

mceclip11.png

mceclip12.png

 

 

Release Date: 02/09/2021

Tech Note Version: 1.0

Product: WRN Wave NVR

Topic: How to fix the WRN routing table when using Corporate Network for Internet access

Procedures:

To Modify the WRN Routing Table, Open Terminal ( Ctrl+Alt+T)

mceclip14.png

Type the Following in Terminal

sudo –s

Enter the WRN WAVE Password and hit Enter

mceclip15.png

Type the Following in Terminal

crontab –e and hit Enter

mceclip16.png

If you are prompted to select editor, type 1 and hit Enter

mceclip17.png

at the end of the file, append the following line

@reboot sleep 5 && sudo route del default dev eth1

mceclip18.png

Press Control + O keys simultaneously

mceclip20.png

Hit Enter Key to accept the file name

Press Control + X keys to exit the editor mode 

Reboot WRN

Copyright © 2021 Hanwha Techwin America.
All rights reserved