Follow

SNP-6200/6200H Resumption of Tour Mode After Alarm Event Functionality

 

PRODUCT CATEGORY: Network Cameras

MODEL NUMBER: SNP-6200/6200H

TECH TIP SUBJECT: Resumption of Tour Mode After Alarm Event Functionality

The SNP-6200/6200H are able to be programmed for this mode of operation. The menu screens are shown below but are not called out in the USER MANUAL.

 To set the camera to go back into the auto run tour after an alarm triggered preset, go to:

o Setup > PTZ setup > Preset Setup > Preset Edit > Special > After Action= Auto run, Apply.

(see screen shots below)

 Be sure that each preset created for the tour is configured to the After Action= Auto run setting.

 

 

Copyright © 2016 Hanwha Techwin America.
All rights reserved