Genetec - Adding Hanwha Techwin SPC-7000 keyboards to Security Desk June 09, 2021 21:39 Updated The Hanwha Techwin SPC-7000 keyboard works in PTZ and DVR mode with Security Desk. To use the Hanwha Techwin SPC-7000 keyboard you must first configure the Peripherals settings in Security Desk. Before you begin Perform a factory reset of the keyboard. For more information, see your Hanwha Techwin documentation. Procedure From the home page in Security Desk, click Options > Peripherals > Keyboard. From the Keyboard protocol drop-down list, select Hanwha Techwin SPC-6000/7000. 3. Configure the Baud rate as shown: 4. Click Save Notes about using the Hanwha Techwin SPC-7000 keyboard Keyboard settings are enabled from the unit's interface or directly on the keyboard. Click the Camera key on the keyboard, and select your camera to set or execute the following functions: The PTZ Control option. The Preset option. The Trace option. The Iris, Focus, and Zoom option. Click the Recorder/SSM key on the keyboard to control playback: Select DVR and enter the DVR device id that you already created. Click the arrow key to expand the menu. Click Search to switch modes. For more information, please consult the operating Manual Adding a device to a Hanwha Techwin SPC-7000 To add a device to the SPC-7000, you must configure the settings on the keyboard's interface. Procedure: From the onscreen menu, go to Settings > Device. Click Add at the top of the screen. Click Manual registration. On the registration form, click Analog. Under Type, select Analog camera. Under Protocol, select Samung-T. The Baud rate should match what is configured in Security Desk (9600). Click OK. . Using keyboard controls Keyboard settings are enabled from the unit's interface or directly on the keyboard. Procedure From the onscreen menu, click Camera. Select your camera, and click OK. In the camera menu, use the PTZ controls and patterns and presets. Related articles SPC-7000 Factory Default How do I obtain current and past firmware? Genetec - Using the auto-run command with Hanwha Techwin units in Security Desk What Access Control Manufacturers are supported in WAVE? How do I capture the logs from Wisenet Viewer?