Applies to Models: Q, P, and X series NVRs
IP Filtering adds an additional layer of access restrictions, this function is for blocking or allowing certain IP's from connecting, it is restricted to the Network cards in the recorders.
NOTE: It is not for blocking unknown devices from taking over a
cameras IP address
Step By Step Guide:
1. Navigate to Network/IP Filtering (Figure 1)
2. Put the Filtering Type switch to "Allow" or "Deny" (Figure 1)
NOTE: With the switch on "Allow" only devices in the list are
ALLOWED to connect to the NVR.
With the switch on "Deny" you are blocking those specific IP
addresses from connecting to the NVR
3. Click OK to commit your change