Follow

Camera - Wisenet X-Series Accessing the camera by USB WiFi

X-Series Cameras feature a micro USB connector. With a specific WiFi  adapter attached to the USB connector, wireless setup of the camera is possible using the Wisnet Installation application available for Android and IOS. The link below is to a document explaining the Android and IOS setup

https://support.hanwhasecurity.com/hc/en-us/articles/115006389767-Camera-Wisenet-Installation-Easy-Setup-via-USB

It is also possible to utilize a WiFi enable laptop accessing the camera directly using the same setup. How ever, since the camera can not configure the WiFi adapter and acting as a router, a different procedure is used to accomplish the same.

  • Step 1: Assure that  the correct model WiFi adapter is installed in the camera. If using a metal case camera, please put the adapter near the glass portion of the camera, this is needed to improve wireless communication with the camera.
  • Step 2: On the Laptop open the WiFi network setup utility and search for the camera. The SSID should include the camera model number. The PC WiFi should be in DHCP mode. In the example below, the top SSID would be the one to select.

 

mceclip5.png

Connect to the camera

mceclip6.png

 

  • Step 3: Once connected, open up a command prompt window and type: ipconfig

mceclip2.png

Locate the WiFi adapter and write down the default gateway, in the example above it would be 192.168.100.1

  •  Step 4: Open up a web browser and and enter the gateway information in to the address bar (Just  type the gateway IP)

mceclip3.png

 It should prompt for the log in window

mceclip4.png

That is all that is needed

 

Copyright © 2019 Hanwha Techwin America.
All rights reserved