Follow

Genetec - Adding a Hanwha Camera to Genetec 5.7 or later

This article will go as far to add a Hanwha device to a Genetec 5.7 or later system.

All system configurations in Genetec happen in the "Config Tool"

Please go into the Config ToolConfig_tool_app.png

Genetec_VU2.png

Genetec_VU3.png

In the screen above the Manufacturer selected should be Hanwha Techwin.

The IP Address can be a single device or a range of devices. 

Provide the proper credentials and click either "Add and close" or "Add". Then repeat for further units.

Genetec refers to the configuration section for Cameras as "Video Unit" 

To configuring the cameras, this is the section to look for. Below is a picture of a camera that has been successfully added. And is streaming as evidenced by the preview box on the right.

Genetec5.7_VU4.png

 

 

 

Copyright © 2019 Hanwha Techwin America.
All rights reserved