Follow

Mobile - TRM-410S / 810S WiFi Setup

The Mobile recorders TRM-410 and TRM-810 feature two wired network connections and one WiFi connection.

While the hard wired connections are standard like most other NVRs', the wireless maybe be outside the standards used normally to connect in a WiFi environment. 

It is important to realize that the connection is made for retrieving or archiving video.

Below is a typical example for such setup

mceclip0.png

 

 

Please take note of the specifications for the WiFi connection:

WiFi internal (802.11 ac(5G)) only

DHCP on WiFi is not supported, this requires to reserve and know the network settings and connections properties before initial connection setup.

To start the setup of a Wireless Connection, the following information is required:

  1. SSID
  2. Password
  3. IP
  4. Subnet Mask
  5. Gateway
  6. DNS

The setup can be done form a wired network connection to the recorder or by built in mouse and HDMI connected monitor

Go to the network setting

 

1.JPG

Enable WiFi  and click on setup

2.JPG

 

Now enter the predetermined IP, Sub-net Mask, Gateway and DNS, than click on WiFi settings

The values below are just examples

 

3.JPG

Select the appropriate network. double click on it

4.JPG

Enter the Network password

 

5.JPG

 

6.JPG

 Wait for the confirmation

7.JPG

 After acknowledgment, set the default Gateway to network 3 and click OK

8.JPG

10.jpg

 

 When getting the message below, the procedure should be complete9.JPG

 Wait a few seconds and try connecting by Wireless using the IP select in the above procedure.

 

 

 

Copyright © 2019 Hanwha Techwin America.
All rights reserved