Follow

Wisenet Wave - WRN (WAVE PoE NVR) Setup Wizard Guide

1. Power on the NVR to log in to the desktop

    a. Default user is wave

    b. Designate a new password

mceclip0.png

    c. Retype the new password and log in.

mceclip1.png

2. Click on the WRN Setup Wizard icon found on the desktop taskbar.

mceclip2.png

3. Enter the password created in Step 1 and press OK.

mceclip3.png

4. a. Configure the Date & Time and press Apply to continue

mceclip4.png

    b. Click Yes to confirm the settings

mceclip5.png

5. Configure Network Settings

mceclip6.png

    a. Network 1 (Camera) Setup

        - Select DHCP or Manual Mode to manually enter the static IP address, Subnet mask, Default Gateway and DNS of the NVR.

mceclip7.png

    b. Network 2 (Corporate) Setup

        - Select DHCP or Manual mode

    c. Enable DHCP for PoE Ports

    d. Configure the Starting IP address of the DHCP pool range

    e. Configure the Ending IP address of the DHCP pool range

    f. Configure the maximum number of available DHCP devices

    g. Configure the Lease Time (Hours) of DHCP IP addresses

    h. Configure primary DNS

    i. Configure secondary DNS

Click Apply and Yes to confirm the settings

mceclip8.png

6. The WRN Setup wizard will scan for any connected cameras

mceclip9.png

7. The connected cameras will show up in a list along with the status of the cameras.

mceclip10.png

8. a. Select the cameras by holding the <CTRL> or <SHIFT> key

    b. Enter the Password for the cameras.

    c. Click Connect

mceclip11.png

9. When the status of a camera shows as connected, you may change the password for the camera

mceclip12.png

10. To finish, click Apply and Yes to confirm the settings

mceclip13.png

Copyright © 2019 Hanwha Techwin America.
All rights reserved